Abstract

WATSON, B.P.; MAPHOSA, T.J.; ROBERTS, D.P.  and  GARDNER, L.J.. Determination of strength of UG2 chromitite pillars at Impala Platinum from laboratory tests and FLAC3D. J. S. Afr. Inst. Min. Metall. [online]. 2024, vol.124, n.8, pp.437-446. ISSN 2411-9717.  https://doi.org/10.17159/2411-9717/3261/2024.

The results of FLAC3D modelling on chromitite Upper Group 2 Reef pillars from the Bushveld Complex of South Africa are described. The model input parameters were determined from laboratory triaxial tests with post-failure measurements. These geomechanical tests were performed on rock materials within the pillars and the immediate pillar foundations. In the models, post-failure behaviour was simulated using the concept of cohesion softening. Models were built to determine the strength and behaviour of pillars with a width-to-height ratio of approximately two. The original research aimed to find a suitable depth below the surface where Impala Platinum Ltd could safely introduce crush pillars; however, the paper only describes the model results: the ideal depth of the crush pillar introduction is not discussed. The results of the modelling are compared with the PlatMine formula for peak pillar strength and with an underground instrumented pillar located elsewhere on the same reef. Some insight into the effects of grid size on strength is also provided. Further underground measurements are recommended to verify the model results.

Keywords : pillar strength; laboratory rock tests; FLAC3D; modelling parameters; post-failure; machine stiffness; crush pillars.

        · text in English     · English ( pdf )