SciELO - Scientific Electronic Library Online

vol.39 número5A comparative study on growth performance of crossbred and purebred Mecheri sheep raised under dry land farming conditionsHerbage yield in Signalgrass pastures as affected by grazing management índice de autoresíndice de materiabúsqueda de artículos
Home Pagelista alfabética de revistas  

Servicios Personalizados



Links relacionados

  • En proceso de indezaciónCitado por Google
  • En proceso de indezaciónSimilares en Google


South African Journal of Animal Science

versión On-line ISSN 2221-4062
versión impresa ISSN 0375-1589

S. Afr. j. anim. sci. vol.39 no.5 Pretoria ene. 2009


A comparison between hominy chop and defatted maize germ meal as the main energy source in diets of feedlot steers



K-J. LeeuwI,#; H.H. Meissner1; D. Palic2

IARC-Animal Production Institute, Private Bag X2, Irene 0062, South Africa




Defatted maize germ meal (DMG) is arbitrarily rated at a lower economic value than maize meal or hominy chop (HC). Five treatments with 15 steers each were fed different inclusion levels of DMG (0%, 25%, 50%, 75% and 100%), replacing hominy chop during the fattening period. Slaughter data were collected for carcass performance evaluation. DMG has lower fat levels and higher NDF (fibre) levels than HC. A slightly higher feed intake (8.1% for T5 vs. T1) and lower gain (-4.4% for T5 vs. T1) of steers on DMG containing diets resulted in a 9 to 14% poorer feed conversion ratio in comparison to steers on the HC diet. No differences were observed between carcass weights for all treatments and dressing percentage did not differ between T1 (57.4%) and T5 (57.8%). Pricing levels need to be adjusted to reflect the nutritional value of DMG.

Keywords: Economic value, steer performance, carcass performance




The animal feeding industry, in particular the feedlot industry, estimates a 15 to 20% lower (2004) (M. Savage, Personal communication, ) economic value for defatted maize germ meal (DMG) in comparison to hominy chop (HC). This is based on the assumption that DMG will give a lower performance value (D. Ford, Personal communication, ), since it contains less metabolisable energy than HC, which therefore implies that more DMG will be needed to fatten a feedlot animal. To test the validity of the assumption, feedlot steers in this study were to be fed either DMG or HC as the main energy component, employing a substitution design. Growth performance and carcass production were compared to facilitate an economic evaluation and calculation of a relative price for DMG. Therefore this study was done to establish whether prices paid for DMG are in line with its nutritive value (Savage, Personal communication).


Materials and Methods

Animal ethics approval was obtained from the Agricultural Research Council Animal Ethics Committee. Seventy five Bonsmara steers with an initial weight of ca. 190 kg (± 21 kg) were blocked by weight into five treatments with 15 animals each. The steers were weighed, preventatively vaccinated against bacterial and viral diseases, treated for internal and external parasites, implanted with a growth hormone (Revalor S®) and given a numbered ear tag. The steers were housed in 2 m2 single stanchions fitted with a water drinker and feed trough. The trial period lasted for 124 days, whereafter the animals were slaughtered at a commercial abattoir where carcass weights and grading data were collected.

Formulated diets were similar to a commercial diet with an estimated 140 g crude protein/kg, 100 g fibre/kg, 7 g Ca/kg and 4 g P/kg. Treatment 1 (T1) contained only HC as main energy source; treatment 2 (T2) 75% HC and 25% DMG; treatment 3 (T3) 50% HC and 50% DFG; treatment 4 (T4) 25% HC and 75% DMG and treatment 5 (T5) only DMG (Table 1). During the trial period DMG and HC were delivered at different times and therefore the batches were sampled and analysed for nitrogen, fat, starch and NDF (AOAC, 2003). The steers were adapted to the final diet in 15 days, by reducing roughage content from 15% to 5% with 2% intervals every three days, while increasing the DMG and HC content of the respective diets correspondingly.

Data were analysed with the ANOVA statistical programme, GenStat (2000). Treatment means were separated using Fishers' protected t-test. Least significant difference (LSD) was accepted at the 5% level of significance (Snedecor & Cochran, 1980). DMG and HC feed conversion ratio (FCR) evaluation, in support of calculation of relative economic values, were estimated from regression analysis.


Results and Discussion

The results of the chemical analysis are shown in Table 2. As was expected, DMG had a lower fat level and a higher neutral detergent fibre (NDF) level than HC. The animal performance parameters are presented in Table 3. Non significant differences were observed for steer weight, average daily gain (ADG) and carcass grading. Feed conversion ratio (FCR) differed (P <0.05) between treatments (Table 3), with a clear advantage to treatment T1. The significant difference observed for dressing % is probably due to the higher feed intake of steers in treatment T2 in the two weeks prior to the animals being slaughtered, resulting in higher digestive track fill for this treatment (data not presented). No significant difference in dressing % due to differences between HC and DMG were recorded. In Table 4 the performance of steers on T2, T3, T4 and T5 was compared in relation to steers in treatment T1. Although not different (P >0.05), it is evident that a slightly higher feed intake and lower gain of steers on DMG containing diets resulted in a 9 - 14% poorer feed conversion ratio in comparison to steers on the HC diet.

To conduct an economic evaluation of the experiment, a price structure was used for the diets mixed (South African Rand - ZAR/1000 kg). DMG was taken as the unknown, HC was priced at ZAR 920.00, wheat bran at ZAR 900.00, brewers grain (dried) at ZAR 960.00, molasses meal at ZAR 850.00, hay at ZAR 800.00, cotton seed (whole) at ZAR 2 300.00, feed lime at ZAR 380.00, urea at ZAR 2 500.00, salt at ZAR 420.00 and vit./min. premix at ZAR 18 000.00. These were used to calculate the dietary costs for the various treatments and in the analysis shown in Table 5. T5 was used in comparison to T1 to calculate the amount that can be paid for DFG if HC costs ZAR 0.92 per kg (ZAR 920 per ton). The calculations are presented in terms of ZAR feed cost per kg of gain. The estimated cost for DMG per kg is 14% below that of HC (0.79/0.92 × 100), which coincides with the 14% difference observed in FCR between T1 and T5 (Table 4). This also seems to coincide with the 14% difference observed in FCR between T1 and T5 (Table 4.). However, if a linear regression equation, which takes individual variation into account (Figure 1), is considered a 12% difference is calculated between T1 and T5:

(0.1453 × 1) + 4.7173 = 4.8626 and (0.1453 × 5) + 4.7173 = 5.4438, with ((5.4438 / 4.8926) - 1) × 100 = 12%.



The different calculation methods correspond satisfactorily. They indicate a 12 - 14% lower value for DMG compared with HC in feedlot diets, i.e. better than the industry accepted 15 - 20% lower value. This implies that if HC is ZAR 1 700 per ton (2008 price), DMG can be priced at ZAR 1 480 per ton as the maximum. However, this does not imply that the same value can be used in diets other than cattle feedlot diets. The probability of confounding dietary effects was not investigated, as a direct replacement of hominy chop by DMG was regarded as the main focus of the study. This does, however point to future research possibilities for DMG inclusion in high concentrate diets.



The authors wish to thank Ruto Mills (Pty) Ltd. for their financial support.



AOAC, 2002. Official methods of analysis, 17th ed. Association of Official Analytical Chemists, Inc. Arlington, Virginia, USA.         [ Links ]

GenStat for Windows, 2000. Release 4.2. Fifth Ed. VSN International Ltd., Oxford.         [ Links ]

Snedecor, G.W. & Cochran, W.G., 1980. Statistical methods (7th Ed.). Iowa State University Press.         [ Links ]



# Corresponding author. E-mail:
1 Present address: 189 van Riebeeck Avenue, Centurion 0157, South Africa
2 Present address: Institute for Food Technology, Bulevar cara Lazara 1, 21000 Novi Sad, Serbia

Creative Commons License Todo el contenido de esta revista, excepto dónde está identificado, está bajo una Licencia Creative Commons