Resumo

MOHOLWA, M.S.; STEENKAMP, J.D.  e  RUTTO, H.L.. Fines generation from South African manganese ores during preheating in a rotary kiln. J. S. Afr. Inst. Min. Metall. [online]. 2022, vol.122, n.11, pp.629-638. ISSN 2411-9717.  http://dx.doi.org/10.17159/2411-9717/1724/2022.

Manganese ores are the major source of manganese for the production of manganese ferroalloys. There is a gap in the knowledge of the decrepitation behaviour of manganese ores, which presents a problem in the operation of smelters. Decrepitation, which is the breakage of the ore particles upon heating, is an important quality parameter for these ores. The purpose of this investigation was to determine the extent to which South African manganese ores decrepitate during preheating in a rotary kiln. The effects of temperature, rotational speed, and particle size decrepitation were investigated. Manganese ores were heated in a laboratory-scale rotary kiln at temperatures of 600, 800, and 1000°C, and rotational speeds of 3, 6, and 12 r/min. The size ranges were +6-20, +20-40, and +40-75 mm and the residence time was constant at 30 minutes. The decrepitation index (DI) is quantified as the ratio of the mass of <6 mm particles after pre-heating to the total mass of the sample. It was found that the DIs for all ores used were proportional to the temperature and the rotational speed and inversely proportional to the particle size range with temperature being the most important parameter. Ore A was the most susceptible to decrepitation followed by ore C and ore B; this was mainly to the decomposition of kutnohorite, the content of which was the highest in ore A and the lowest in ore B.

Palavras-chave : decrepitation; manganese ores; rotary kiln; temperature; rotational speed; size range.

        · texto em Inglês     · Inglês ( pdf )