Resumo

DU PLESSIS, M.  e  MALAN, D.F.. Mining with crush pillars. J. S. Afr. Inst. Min. Metall. [online]. 2018, vol.118, n.3, pp.211-216. ISSN 2411-9717.  http://dx.doi.org/10.17159/2411-9717/2018/v118n3a3.

Crush pillars have been extensively applied on the Merensky Reef horizon since the late 1970s. Once in a crushed state, the residual strength of the pillar provides a local support function and must support the hangingwall to the height of the highest known parting. The design of crush pillars is mainly limited to specifying a width to height ratio (w:h) of approximately 2:1. It is also required that a pillar crushes close to the face, while the pillar is being formed. On many mines the crush pillar system is problematic owing to the difficulty of controlling pillar sizes. This is mainly caused by poor drilling and blasting practices. As a result, pillar crushing is not always achieved. Crush pillars are implemented at relatively shallow depth, the pillar dimensions have remained essentially unchanged over many years, and the impact of regional pillars and geological losses contributing to the regional behaviour of the rock mass are overlooked. In many cases the pillar system is the source of seismicity. In this paper, the influence of mining losses (potholes) and the use of sidings are discussed as possible contributors impacting on crush pillar behaviour. A limit equilibrium model implemented in a displacement discontinuity boundary element program is used to demonstrate crush pillar behaviour. The results are compared to the pillar behaviour at an underground investigation site, which supports the preliminary findings.

Palavras-chave : crush pillar behaviour; limit equilibrium model; regional pillars; geological losses.

        · texto em Inglês     · Inglês ( pdf )