Resumen

MATJEKE, V.J. et al. Effect of yield strength on wear rates of railway wheels. J. S. Afr. Inst. Min. Metall. [online]. 2016, vol.116, n.10, pp.947-955. ISSN 2411-9717.  http://dx.doi.org/10.17159/2411-9717/2016/v116n10a9.

Excessive wear rates on railway wheels can result in rolling-stock derailments. If wear is detected early the possible derailments can be prevented by prematurely replacing wheelsets, although the inventory cost and maintenance downtime remain a challenge. In the current study, wheels were introduced and monitored in-service for two years to investigate the cause of excessive wear rates. The wear rates and stresses were calculated for the wheels suitable for a maximum load of 26 t per axle. Microstructural and mechanical properties were analysed. As expected, the general microstructure of all the wheels tested was pearlitic. Although all the wheels complied with the tensile strength requirements, stress calculations confirmed material distortion on excessively worn wheels whereas trial wheels revealed yield strength exceeding the yield criterion. High wear rates observed on the wheels were a result of low yield strength relative to the load per axle. The typical wear mechanism found was due to a combination of rolling contact fatigue and abrasive brake wear. Despite compliance of the wheels with existing requirements regarding material and mechanical properties (hardness, ultimate tensile strength), it is recommended that the yield strength must also be taken into consideration as a critical parameter.

Palabras clave : railway wheels; wear rate; yield strength; wear mechanism; rolling contact fatigue.

        · texto en Inglés     · Inglés ( pdf )