Resumo

BIAN, X-Y; CHEN, X-Y; LU, H-L  e  ZHENG, J-J. Determination of base and shaft resistance factors for reliability-based design of piles. J. S. Afr. Inst. Civ. Eng. [online]. 2018, vol.60, n.2, pp.53-60. ISSN 2309-8775.  http://dx.doi.org/10.17159/2309-8775/2018/v60n2a6.

This paper aims to propose a procedure for calculating separately the resistance factors for ultimate base and shaft resistances for the reliability-based design of piles. The proposed procedure can clearly explain the different sources of uncertainties of the bearing capacity, including those from ultimate base and shaft resistances. The study evaluates the convergence of the proposed procedure, and the effects of relevant parameters on resistance factors. Finally, two examples are used for comparison and application of the presented method for determining ultimate base and shaft resistance factors. Convergence analysis proves that the final resistance factors can be rapidly obtained, and maintain good stability using the iteration algorithm included in the proposed procedure. A parametric study indicates that the ratio of dead load to live load and initial values of the ultimate shaft (or base) resistance factor, have a limited effect on the final convergence values of ultimate shaft (and base) resistance factors. However, the target reliability index has significant influence on the ultimate shaft and base resistance factors. The validation example shows that the ultimate shaft and base resistance factors, as calculated in this paper, are conservative compared to the results by Kim et al (2011), due to the consideration of more uncertainties. The recommended ultimate shaft and base resistance factors for the reliability-based design of piles can be obtained conveniently using the proposed procedure in the application example.

Palavras-chave : pile; reliability; resistance factor; ultimate base resistance; ultimate shaft resistance.

        · texto em Inglês     · Inglês ( pdf )